By turning the four CODE DIP switches ON or OFF, you can apply a configuration to the Synergis™ Cloud Link appliance.
DIP switch commands
| S1 | S2 | S3 | S4 | Command description |
|---|---|---|---|---|
| ON | ON | ON | ON | No code: After running a command code, to avoid an accidental configuration change, set the DIP switches to ON ON ON ON. |
| ON | OFF | OFF | OFF | Partial factory reset. This command has the following effects:
NOTE: The unit firmware is not affected by this
command.
|
| ON | OFF | OFF | ON | Resets all settings to factory defaults and removes SSL certificates. |
| OFF | OFF | ON | OFF | Re-enables the ability to change output states from the I/O diagnostics page of the Synergis™ Appliance Portal. |