For Security Center to communicate with Bosch
B series or G series intrusion panels through an IP network, you must configure the panel
settings before you add the unit in Security Center.
Before you begin
Read the Bosch quick start guide and installation guide that applies to your
hardware.
Procedure
-
Select one of the supported Ethernet
modules.
-
Enable communication between the Bosch Management Remote Programming Software (RPS)
and the panel, using a USB cable, the onboard Ethernet communication module, the B420
Ethernet module, or the B426 Ethernet module.
For more information about enabling communication between RPS and the panel, see
your Bosch documentation.
-
Configure the panel settings using Bosch RPS, such as the intrusion areas, inputs
(points), outputs (relays), automation mode of operation (1 or 2), and other
behavior.
For more information about configuring the panel settings using Bosch RPS, see
your Bosch documentation.
-
Enable communication between Security Center and the panel, using the onboard Ethernet communication module, or using the B420 or B426 Ethernet
modules.
For more information about enabling the panel to communicate with a server over an
IP network, see your Bosch documentation.