Before you begin
Create an
Intrusion Manager role to manage the unit.
Procedure
-
From the Config
Tool home page,
open the Intrusion detection task.
-
Click Intrusion detection unit ().
-
From the Unit type drop-down list, select the manufacturer.
-
Enter the IP address (host address) of the intrusion
panel.
-
In the Port option, select the port number you configured on
the panel.
-
In the Automation protocol option, select the automation
mode of operation (Mode 1 or Mode 2) you configured on the panel.
IMPORTANT: The default port for Mode 1 is 7702, and the default port for Mode 2 is 7700.
If the automation mode does not match the setting on the panel, it will not connect.
-
In the Passcode option, type the passcode you configured on
the panel.
The password is configured using the AUTOMATION / REMOTE
APP section of the Bosch RPS.
-
(Optional) If your Bosch panel is not yet physically connected to the network, but
you have the connection settings pre-planned, you can pre-enroll the panel into
Security Center by selecting the
Enroll disconnected unit option.
IMPORTANT: Before using this option, make sure that all pre-installation
steps have been completed and that the connection information is correct.
Additionally, when using this option, the intrusion panel entity you add will
remain offline until the intrusion manager role can successfully communicate with
the panel.
-
Click Add and close.
Results
The intrusion detection unit is
displayed under the Intrusion Manager role in the entity browser.
After the unit is connected, the Intrusion Manager automatically creates the intrusion
detection areas (zones and partitions), inputs (points), and outputs that are configured on
the panel.