If you want to see statistics about such things as the number of total reads or the number of accepted hits, you can check your Genetec Patroller™ statistics from the Status screen.
What you should know
Procedure
To view your Genetec Patroller™ statistics:
In the main Genetec
Patroller™ window,
tap Status, then tap
Statistics.
NOTE: The following screen capture is an example. The
information displayed in the window varies depending on the Genetec
Patroller™ mode you are running.
Results
The Statistics window provides the following information:
NOTE: The
camera information listed is dependent on the
cameras that are installed and in use on the
vehicle.
- Manual
- Number of manually captured reads.
- Front left/right
- Number of reads made by the front left/right ALPR camera(s).
- Rear left/right
- Number of reads made by the rear left/right ALPR camera(s)
- Front center/Rear center
- Number of reads made by the front or rear center camera(s).
- Total
- Total reads made.
- Zone
- (MLPI only) Shows the location of the Parking facility that is being patrolled.
- Permit
- (City and University only) Shows the currently selected permit restriction (if applicable).
- Overtime rule
- (City and University only) Shows the currently selected overtime rule (if applicable).
- Count
- (City and University only) Shows how many hits received for the permit restrictions and overtime rules.
- Accepted
- Number of hits you have accepted.
- Unresolved
- Number of pending hits that you have not accepted or rejected.
- Hits/Reads ratio
- The ratio of hits to reads.
- Pending upload
- (City, University only) Shows how many reads must be uploaded and shared with other patrol vehicles registered with the same Plate link account.