Creating event-to-actions for instrumented areas - Security Center Transportation Sensor Management 2.3

Using an event-to-action, you can trigger actions to occur when an instrumented area reaches a configured occupancy threshold.

1. From the Config Tool home page, open the System task, and click the General settings view.
2. Click the Actions page, and click Add an item ().
3. Configure your event-to-action:
   1. From the When drop-down list, select Instrumented area occupancy state change.
   2. Click Specify a condition, and type "NewState":X, where X is one of the following:
      • 0: Unknown capacity. Used when there is no data for the instrumented area.
      • 2: Normal. Used when the occupancy is below the configured high occupancy threshold.
      • 3: At capacity. Used when the occupancy is above the configured high occupancy threshold, but not the maximum capacity.
      • 4: High capacity. Used when the occupancy is above the maximum capacity.
   3. In the From option, select your instrumented area.
   4. From the Action drop-down list, select an action type and configure its parameters.
   5. In the Effective option, click Always, and select a schedule when this event-to-action is active.
      If the event occurs outside of the defined schedule, then the action is not triggered.
4. Click Save.