LP2500 connections - Synergis™ Cloud Link

Synergis™ Cloud Link Hardware Installation Guide

Applies to
Synergis™ Cloud Link
Last updated
Content type
Guides > Installation guides
Synergis™ Cloud Link

As part of your installation, you might need to include a Mercury LP2500 intelligent controller.

IMPORTANT: LP controllers include a Micro USB port. This connection is not to be used if UL/ULC listed access control system compliance is required and is to be maintained.

The following diagram demonstrates how to connect the controller.

LP2500 unit with connections
A Power In Connect + to VIN (observe polarity). Connect - to GND. Use 20 AWG wires minimum.
B Ethernet cable Connect to the Synergis™ Cloud Link directly or through the network infrastructure.
C RS-485 bus RS-485 bus connection to other Mercury modules.