You can use the four inputs on the Synergis™ Cloud Link appliance to monitor external events in the access control system.
The monitoring inputs can be configured by software as supervised or unsupervised,
each requiring a specific resistor configuration.
NOTE: Synergis Cloud Link inputs must not be used as REX (Request To
Exit) in UL294-compliant installations.
Monitoring input connector pinout
Pin | Description |
---|---|
+ | Input signal |
- | Input return signal |
Resistor configuration
The supervision of Synergis Cloud Link monitoring inputs must be configured in Config Tool. For more information, see Configuring the monitoring inputs on the Synergis Cloud Link appliance.
Refer to the following electrical diagram for information on how to configure the resistors.
3-state supervision wiring
Normally closed:
Normally open:
4-state supervision wiring
Normally closed:
Normally open:
Unsupervised input wiring
Normally closed:
Normally open: