Changing the connection configurations of alarm receivers - Receiver 3.1

Receiver Intrusion Detection Extension Guide 3.1

series
Receiver 3.1
revised_modified
2020-06-09
category_custom
Guides > Plugin and extension guides
prodname_custom
Ecosystem (add-ons) > Receiver
vrm_version
3.1

If required, you can change the IP address and port of an existing alarm receiver.

What you should know

When there are multiple alarm receivers, make sure that each receiver has a unique port number, even if the receivers are on different IP addresses.

Procedure

  1. From the Config Tool home page, open the Intrusion detection task.
  2. Select the alarm receiver from the entity tree.
  3. Click the Properties tab.
  4. In the Connection configuration section, change the IP address and the port number.
    Receiver intrusion detection unit IP configuration
    NOTE: If you are using a DSC Sur-Gard receiver over a serial connection, you can change the COM port.
    Receiver intrusion detection unit serial configuration
  5. Click Apply.

Results

The unit goes online when an event is received from the receiver, which will most likely be the receiver's heartbeat message.