To integrate MCE Sentry systems in Security Center, you must install the plugin on all Security Center servers and client workstations.
Before you begin
Ensure the following:
- Your servers meet the recommended system
requirements.
- A compatible
version of Security Center is
installed.
-
IMPORTANT: The protocol used by MCE Sentry Destination Dispatch does not
require authentication or authorization to connect. The plugin should be deployed on the
same subnet as the third-party MCE Sentry system, within a closed network.
-
Tip: It is a best practice to host the plugin role on a dedicated expansion
server for best system performance, and to enable failover.
Procedure
-
Open the GTAP Product Download page.
-
From the Download Finder list, select your version of Security Center.
-
Search for the MCE Sentry Destination Dispatch plugin package and download it.
-
Click the downloaded .exe file to unzip it.
By default, the file is unzipped to
C:\Genetec.
-
Stop the Genetec™
Server, and close
Security
Desk and Config
Tool.
-
Open the extracted folder, right-click the setup.exe file, and
click Run as administrator.
-
Follow the installation instructions.
-
On the Installation Wizard Completed page,
click Finish.
IMPORTANT: The Restart Genetec™
Server option is selected
by default. You can clear this option if you do not want to restart the Genetec™
Server immediately. However, you must
restart the Genetec™
Server to complete the
installation.