Video is streamed in high resolution on a Barco display (video wall), therefore, to
configure specific settings for streaming on the Barco display and to reduce bandwidth usage
on the network, you must enable and configure the High resolution stream in Config
Tool for all the cameras you want to display
on the
wall.
What you should know
If you are using
Security Center 5.8.1 or
later, you must disable encryption on the video stream. There are two ways to do this:
Procedure
-
From the Config
Tool home page,
open the Video task.
-
Select the camera that you want to view on the Barco display, and click the
Video tab.
-
If the camera supports multiple video streams, select the video stream tab at
the bottom of the Video tab corresponding to the video
feed that you want to display on your wall.
-
In the Stream usage section, select High
resolution.
- Optional:
If your camera is configured to be part of a camera sequence, and you want to
minimize delays when switching between video feeds, do the following:
-
In the Quality drop-down list, select
Custom.
-
Increase the Key frame interval.
-
In the Network settings section, select
Multicast from the Connection
type drop-down list.
The connection type defines how communication between the Archiver and the
camera is established for sending or receiving video streams. If multicast is
not available, then select Best available.
-
Click Apply.