Configuring the Evervision IPE4100 with PTZ control - Security Center 5.10.4.0

You can configure the IPE4100 to use PTZ control.

1. Open the unit's web page.
2. Navigate to the Setup page.
3. Click IO Configuration to open the PTZ Configuration page.
4. Select from the PTZ Protocol drop-down list one of:
   • TBT.
   • Pelco-P.
   • Pelco-D.
5. Click Apply.
6. Add the unit to Security Center.
   If your unit was already part of the Security Center system, restart the unit for your changes to take effect.