For Hanwha Techwin PTZ units that support the auto-run command, to use the command in
Security Center, you must perform some additional
configuration steps on the unit's web page, and then enable the command in Security
Desk.
Before you begin
Make sure auto-run is enabled on the unit from the unit's web page.
What you should know
If you configure the auto-run settings on the unit's web page, such as the auto-run
mode (Swing, Group, Tour, Trace, Auto pan, and so on) and the auto-run parameters, those
settings are used by default in
Security Center
when you add the unit in
Config
Tool.
Procedure
-
From the Video task in Config
Tool, select the camera to
configure.
-
Click the Hardware tab.
-
From the Auto run mode drop-down list, select one of the
following auto-run modes:
- Auto pan
- Rotate the PTZ 360 degrees according to the configured speed and tilt.
- Home
- Move the PTZ motor to the home preset position.
- Pattern
- Play the PTZ pattern that was configured. This is called the Trace
mode on the unit's web page.
- Preset
- Move the PTZ motor to the preset position that was configured.
- Preset tour
- Perform a list of configured presets. This is called the Group mode
on the unit's web page.
- Schedule
- Perform an auto-run command according to the configured schedule.
- Swing
- Move the PTZ motor between two presets, according to the configured speed,
dwell time, and swing mode (pan, tilt, or pan and tilt).
- Tour
- Execute a list of configured preset tours.
-
Configure the parameters for the auto-run mode you selected.
For information about the auto-run mode parameters, see your Hanwha Techwin
documentation.
-
To start the auto-run command in Security
Desk, do the following:
-
In Security
Desk, select the
PTZ camera in a canvas tile.
-
In the PTZ widget, click Specific commands (
).
-
In the Specific commands dialog box, click
Enable auto run, and click Execute
command.
To stop the auto-run command, click Disable auto
run.
-
Click Close.