Installing a SharpZ3 auxiliary camera bracket and AutoVu™ auxiliary PoE camera - SharpZ3 | SharpOS 13.4

To install an AutoVu™ auxiliary PoE camera, you must attach it to a SharpZ3 auxiliary camera bracket.

1. Attach the bracket to the hardmount using four hex-head cap screws, flat washers, and split washers.
   
2. Remove the camera dome.
   1. Remove the three Torx-head screws from the camera body using the provided Torx key wrench.
   2. Separate the camera dome from the camera base.
      NOTE: The camera dome is connected to the camera base by a securing strap. You can let the dome hang freely while you install the camera base.
3. Rotate the camera so that the red dot is on the bottom-left.
   
4. Insert the provided mounting bolts through the camera base and through the auxiliary camera bracket.
5. Attach the camera using the provided lock nuts.
6. Rotate the camera so that the white arrow is pointing down.
   
   Tip: You can adjust three axes of rotation.

   
7. Aim the auxiliary cameras according to their positions on the vehicle.
   1. Aim front cameras perpendicular to the direction of travel, and slightly down.
   2. Aim rear cameras in the same direction as the rear SharpZ3 cameras.
      
8. Attach the dome to the camera body and secure it using the three Torx-head screws.
9. Attach the rain guard to the auxiliary bracket using the provided nuts.
   NOTE: The rain guard tabs must be installed behind the bracket as shown.

   
   Tip: Slide the rain guard down from above the camera.