In an environment with a large pool of incidents to monitor, shared by multiple groups
of operators, you can divide the incidents into smaller pools called profiles, and assign
them to different groups, so each group only needs to focus on a small number of incidents,
while allowing the groups to take up each other's workload whenever one of them has a
shortfall.
What you should know
A profile in Genetec Mission Control™ is an incident filter used to
distribute active incidents among the operators who are currently logged on to the
system. Profiles filter incidents by type and by occurrence location.
Procedure
To create a profile:
-
From the Config
Tool home page, open the
Incident configuration task.
-
Click the Profiles view.
-
Click Profile () and enter the
profile name.
-
In the Identity page, enter the Description
of the profile.
-
Under Icon, select an existing icon or click
Add to add a new one.
Genetec Mission Control™
entities share the same set of custom icons. You can use any PNG or JPG file as an icon.
A PNG file with transparent background works best.
-
Click .
-
Under Allowed users, select the users to whom this profile can
be assigned.
Select one of the following:
- Everyone
- All users can be assigned this profile.
- Specific
- Only the configured users and user groups can be assigned this profile.
-
Configure at least one of the next two parameters.
- Incidents
- Incident types and categories that are selected by this profile.
- Location
- Areas corresponding to locations where incidents occurred, selected by this
profile.
-
Click Apply.
The new profile is created deactivated (in red).
To activate the new profile:
-
Select the profile and click Activate () at the bottom of the screen.
All changes are logged in the Profiles audit trails.