Notes about Honeywell encoders - Security Center

Security Center Video Unit Configuration Guide

Applies to
Security Center
Last updated
Content type
Guides > User guides
English (United States)
Security Center

Before adding Honeywell NVE-1008 and ENC-8M2 encoders to Security Center, additional configuration is required on the unit's web page.

When adding the NVE-1008 unit to Security Center, use the IP address of the unit.

On the unit's web page, change the RTP payload type from 104 to another number. This will enable the second stream.

In Config Tool, set the IP address to the multicast address on the unit, and set the UDP port to 60000.

Configure the encoders to match the camera setting on the unit’s web page. For example, if the camera is set to NTSC, you must configure the encoders to NTSC.

On the unit's web page, set the GOP mode to I or IP and the Frame rate reduction to None.