To use permits and shared permits for City and University parking enforcement, permits need to be enabled and configured in Genetec Patroller™ Config Tool.
Procedure
- Open Genetec Patroller™ Config Tool.
- Go to Operation > Permits.
-
Turn on Use permit, then configure the following:
- Auto accept permit hits
- Turn this on if you want Genetec
Patroller™ to accept permit hits with
no user action. After the patrol vehicle has passed through the parking
area, the operator can then review and enforce the hits.
User workflow: Hit raised > Hit is verified against updated permit list > User enforces hit > Hit enforced
- Bypass permit hit enforcement
- Turn this off if you want Genetec
Patroller™ users to indicate whether or
not they enforced the hit after accepting it. Turn it on to bypass
enforcement. When turned on, Genetec
Patroller™ automatically enforces hits
after they are accepted.
User workflow: Hit raised > User accepts hit > Hit enforced
- Auto enforce permit hits
- Turn this on for Genetec
Patroller™ to run in unattended mode.
Hits are automatically accepted and enforced without requiring user
interaction. Hit accept and hit reject surveys are ignored when this
option is enabled.NOTE: The two operator functions (accepting and enforcing hits) are linked when you enable this setting.
User workflow: Hit raised > Hit enforced
-
Turn on Use shared permit (if you’re using them), then
configure the following:
- Auto accept shared permit hits
- Turn this on if you want Genetec
Patroller™ to accept shared permit hits
with no user action. After the patrol vehicle has passed through the
parking area, the operator can then review and enforce the hits.
User workflow: Hit raised > Hit is verified against updated permit list > User enforces hit > Hit enforced
- Bypass shared permit hit enforcement
- Turn this off if you want Genetec
Patroller™ users to indicate whether or
not they enforced the hit after accepting it. Turn it on to bypass
enforcement. When turned on, Genetec
Patroller™ automatically enforces hits
after they are accepted.
User workflow: Hit raised > User accepts hit > Hit enforced
- Auto enforce shared permit hits
- Turn this on for Genetec
Patroller™ to run in unattended mode.
Hits are automatically accepted and enforced without requiring user
interaction. Hit accept and hit reject surveys are ignored when this
option is enabled.NOTE: The two operator functions (accepting and enforcing hits) are linked when you enable this setting.
User workflow: Hit raised > Hit enforced
-
Click Apply.
Permits and shared permits are now enabled and configured in Genetec Patroller™.