Assigning an output to trigger an alarm - Genetec™ Intrusion Protocol 5.0.0

Genetec™ Intrusion Protocol Extension Guide 5.0.0

Applies to
Genetec™ Intrusion Protocol 5.0.0
Last updated
2023-08-04
Content type
Guides > Plugin and extension guides
Language
English
Product
Genetec™ Intrusion Protocol
Version
5.0

For alarms to be triggered from an area, you must assign which output will trigger the alarm.

What you should know

On Telenot panels, you can rename an output, but assigning an output to trigger an alarm is not supported.

Procedure

  1. From the Config Tool home page, open the Intrusion detection task.
  2. From the entity browser, select an intrusion panel and click the Intrusion detection areas tab.
  3. Click the edit button associated with the intrusion detection area.
    Intrusion detection areas page of the Genetec™ Intrusion Protocol extension with edit button highlighted
  4. In the Edit area dialog box, select an output from the Output to trigger alarm list.
    Edit area dialog box
  5. Click Save, and then click Apply.