The Genetec™ Intrusion Protocol extension 5.0.0 supports the following products.
An intrusion detection unit entity represents an
intrusion device (intrusion panel, control panel, receiver, and so on) that is monitored
and controlled by the Intrusion Manager role.
For each device, the corresponding firmware and certification
level is listed.
- Certified
- Genetec Inc. has tested and validated the device.
- Supported by design
- The device shares the same design characteristics as a certified device but Genetec Inc. has not tested or validated the device.
Model | Device type | Firmware | Communications protocol | Certification |
---|---|---|---|---|
B3512 | Intrusion panel | 3.06.012 | Mode 2 | Supported by design |
B4512 | Intrusion panel | 3.06.012 | Mode 2 | Supported by design |
B5512 | Intrusion panel | 3.06.012 3.14.012 |
Mode 2 | Certified |
B6512 | Intrusion panel | 3.06.012 | Mode 2 | Certified |
B8512G | Intrusion panel | 3.06.012 | Mode 2 | Certified |
B9512G | Intrusion panel | 3.06.012 3.14.012 |
Mode 2 | Certified |
Model | Device type | Firmware | Communications protocol | Certification |
---|---|---|---|---|
Integra 24 | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Integra 32 | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Integra 64 | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Integra 64 plus | Intrusion panel | 1.19 | TCP/IP | Certified |
Integra 128 | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Integra 128 plus | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Integra 256 plus | Intrusion panel | 1.19 | TCP/IP | Supported by design |
Model | Device type | Firmware | Communications protocol | Certification |
---|---|---|---|---|
Complex 400H | Intrusion panel | 35.73 | RS232C* | Certified |
* To monitor Telenot panels in Security Center, an RS232/IP converter is required.
NOTE: The firmware version used by Telenot panels cannot be viewed in Security Center.