Supported Synergis™ appliance features for Aperio-enabled lock integration with Synergis™ Softwire 11.2 - Synergis™ Softwire 11.2

Synergis™ Softwire Integration Guide 11.2

Applies to
Synergis™ Softwire 11.2
Last updated
Content type
Guides > Integration guides
Synergis™ Softwire
Integration guides

Not all Synergis™ appliance features are supported with the integration of Aperio-enabled locks from Assa Abloy.

The Aperio-enabled lock integration supports the following Synergis™ Appliance Portal and Synergis™ Softwire features. For a description of these features, see Interface tour of the Synergis™ Appliance Portal.
Synergis™ Appliance Portal and firmware features Supported
Hardware configuration (pre-staging capability)  
Manual enrollment (Add hardware dialog box) Yes
Automatic enrollment (Scan button) Yes
Property configuration Limited1
Configuration cloning (Clone button) Yes
I/O diagnostics (live monitoring of inputs, relays, and readers) Yes2
Interface module firmware display Hub only
Interface module firmware upgrade (apply recommended firmware) No
Double-badge activation Yes
Access control behavior (Synergis™ unit-wide settings)3  
Lock relay (After door opens or When door closes) No
Interlock setting (Single door unlock or Single door open) No
Do not generate Door open too long events when door is unrestricted Yes
Reader setting (Card or PIN or Card only) Yes
Maximum PIN length in digits 154

1 Connection parameters only.

2 Output relays set in the I/O diagnostics page may not take effect immediately, depending on the Status report interval and the Polling interval (v3 locks only) settings.

3 The door behavior settings are overwritten by the individual door settings configured in Security Center.

4 PINs with less than four digits are not accepted.