Configuring the network properties of the Synergis Cloud Link unit - Synergis Cloud Link 2.0.4

Synergis™ Cloud Link Administrator Guide 2.0.4

Applies to
Synergis Cloud Link 2.0.4
Last updated
Content type
Guides > Administrator guides
Synergis Cloud Link

To make sure the Synergis™ Cloud Link unit can be reached on your Security Center system’s network, you must configure the unit's network properties.

What you should know

The Synergis Cloud Link unit comes with a factory-assigned hostname. If your network does not support DHCP, you must assign the unit a new IP address.


  1. Log on to the Synergis Cloud Link unit.
  2. Click Configuration > Network.
  3. In the Access Manager settings section, change the Discovery port if necessary.
  4. In the Network settings section, select the LAN1 or LAN2 as the network interface used to connect the Synergis Cloud Link unit to its Access Manager role, and then configure the unit’s IP address and network properties.
    IMPORTANT: If the unit is not on the same network segment as the Access Manager role, then the unit's IP address must be set to Static IP or DHCP with Static IP allocation.
    Network page in the Synergis™ Appliance Portal.
  5. Click Save.


The Synergis Cloud Link unit restarts, and you are automatically redirected to the unit's new IP address.