Reader connections on the Axis A1001 controller - Synergis™ Cloud Link 2.0.4

Synergis™ Cloud Link Administrator Guide 2.0.4

Applies to
Synergis™ Cloud Link 2.0.4
Last updated
Content type
Guides > Administrator guides
English (United States)
Synergis™ Cloud Link

Each Axis A1001 controller supports up to two readers, called Reader 1 and Reader 2 in Security Center Config Tool. The readers can use either Wiegand (default) or OSDP protocol. For OSDP, the reader must be wired to the first set of reader data A-/B+.

The following chart shows the set of connectors corresponding to the reader on the Axis controller.
NOTE: This pin chart only shows up if the Axis controller is disconnected to the Synergis™ unit.