Pairing Aperio-enabled locks with the AH40 IP hub - Synergis™ Cloud Link 2.0.4

Synergis™ Cloud Link Administrator Guide 2.0.4

Applies to
Synergis™ Cloud Link 2.0.4
Last updated
2022-09-15
Content type
Guides > Administrator guides
Language
English (United States)
Product
Synergis™ Cloud Link
Version
2.0

If you use Aperio-enabled locks with an AH40 hub, you must configure the hub using the Aperio Programming Application (APA) before you can enroll the locks on your Synergis™ unit.

Before you begin

Ensure that you have the following:
  • Aperio Online Programming Application Manual
  • Aperio Programming Application (APA)
  • USB dongle
  • TriBee Bootloader, which includes the USB dongle driver
  • Supported firmwares
  • Computer for running the APA
  • Card that is compatible with the reader

Procedure

  1. Power on the hub.
  2. Plug the USB dongle into your computer and install the following:
    • TriBee Bootloader (driver for the USB dongle)
    • Aperio Programming Application (APA)
  3. Use APA to configure the hub:
    1. Update the firmware on the hub and the locks.
      Best Practice: Upgrade the communication hub before upgrading the locks or sensors.
    2. Pair the hub with the readers.
      Selecting the AH40 IP hub in APA automatically pairs the hub with the readers.
      NOTE: Take note of the port number. You need it to enroll the hub in the Synergis™ Appliance Portal.
    3. Specify the IP address of the Synergis™ unit as the ACU address.
      Example: