Transferring your reader configuration to your STid QR code reader for ClearID - ClearID

Before you can use QR codes as a credential in Genetec ClearID™, you must complete your STid QR code reader configuration by configuring an STiD OCB smart card so that you can transfer the reader configuration to the STid QR code reader.

What you should know

This procedure is for system integrators or account administrators who install and configure QR code readers.

NOTE: Ensure that you have a USB encoder installed and ready to configure your OCB card. For example, the STid Architect® ARC-G desktop reader, enroller, encoder.

1. Launch the STid SECard software to configure your card.
2. In the navigation sidebar, click SCB / OCB.
   
3. Create your STid OCB card.
   1. Place the OCB card on your USB encoder (reader).
      
   2. Click Create Card / Virtual Card to create your configuration card.
      
4. Take the OCB smart card containing your reader configuration to the location of your new QR code reader and pass the card in front of the reader.
   

   NOTE: Your new QR code reader must be online and available for the QR code reader to transfer the QR code reader configuration settings from the smart card to your QR code reader.
5. Verify your QR code reader is still active after the OCB has been swiped on the wall reader.
   1. In Config Tool, open the Access control task.
   2. In the Roles and units view, navigate to and select your access control unit.
   3. In the Peripherals tab Name field, Select your OSDP reader.
      
   4. In the Peripheral tab Name field, verify that the ODSP reader State is Online.
   5. In the Peripheral tab Name field, verify that the Reader State is Active.
   6. Double-click your reader (Reader 1) in the Edit Reader dialog, make sure your settings match the reader settings.
      The following image shows the default Mercury settings: