On the server Properties tab, you can view the network settings configured for this server in Server Admin.
NOTE: All network settings are read-only in Config Tool. They must be configured in Server Admin.
- Public address
- Public address of this server. This setting appears only if a public address is
configured in Server Admin.
- Port
- Port used by the Genetec™ Server service to listen to commands received from other Security Center servers on the public address.
- Proxy
- This switch is turned on if this server is configured as a proxy server for a private network protected by a firewall.
- Private addresses
- List of private IP addresses used for the communication between Security Center servers. Only the private addresses
enabled in Server Admin appear in this list.
- Port
- Port used by the Genetec™ Server service to listen to commands received from other Security Center servers on the private addresses.
IMPORTANT: If the server is running in backward compatibility mode (5.2 or earlier), the first address in the private address list must match the IPv4 properties of the network entity the server belongs to in the Network view task.
- Secure communication
-
Use this section to view the current identity certificate used by the server to communicate with
other Security Center servers.
- Issued to
- Subject of the current certificate. A self-signed certificate created at software installation appears in the form GenetecServer-{MachineName}.
- Issued by
- Name of the certificate authority (CA) that issued the certificate. The issuer and the subject are the same for self-signed certificates.
- Valid from/Expiration
- Validity period of the current certificate.
Click View to open the dialog box to view more information.